Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have made the Printed UWB Antenna Operating Over Multiple Mobile Wireless Standards design from IEEE page in hfss. But after designing I have error/warnings which is
[warning] Warning - Boundary 'Rad1' and Boundary 'gnd_plane' overlap.
Also I don't able to get s11 plot according to...
In IEEE document, Printed UWB Antenna Operating Over Multiple Mobile Wireless Standards, I have the problem to made another side which is right side of spline whereas Left hand side is made correctly in HFSS. How to make it?
Secondly how to made two bottom rectangles which is back side...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
