Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
TL1 and TL2 combined together are providing the matching to diode,cap. and load R altogether. i.e. S11 parameter was obtained obtained at fix input power -20 dBm.My confusion is why S11 at 915 MHz(my operating freq) is -34db.and at the same time when i do HB simulation my power probes are not...
I have simulated half wave rectifier ckt using ADS2009. i have following isssues regarding this.
1. i have made the proper matching ckt using smith chart utility for rectifier ckt i.e.my s11 is good enough but still why all power is not going into the ckt.
i know this depends on power level...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
