Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all
I used SPI interface to communicate between a Spartan-3 FPGA and a TMS320F2808 DSP processor in my design. FPGA is master and DSP is slave. I checked SPISTE_B and SPICLK outputs of the FPGA and they are OK. But DSP does not transmit any data. The TALK bit of SPI peripheral has been...
Do you know "emule"?
Try "emule" and search in it "Radar Systems Analysis and Design Using MatLab".
you can download a 6.05MB ebook that can help you.
if you need and my link allow me, I can upload it.
Re: Can embedded systems compete with FPGAs and DSP Processo
Can embedded systems with RISC microprocessors lead to less development time and efforts versus FPGAs and DSPs in high speed signal processing? For example, can you address me an evaluation borad capable of computing 256-point FFT in...
A typical approach for implementing signal processing algorithms with high computational load is using FPGAs for very high speed pre-processing followed by DSP processors for post-processing. Are there any embedded systems for high speed signal processing that can be used instead of above...
I am designing a data acquisition board and need to send data from the board to PC via an usb 2.0 (high speed) link. The board must work over -40°C ~ +85°C temperature range. Cypress offers CY7C68013A as an industrial USB 2.0 controller but its MOQ and lead time is not suitable for my project...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
