Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
There are 2 library for STM32 microcontrollers. The HAL Library and The Standard Library.
The stm32cube use HAL Library. May be proteus is using the standard library
Proteus generated minimum code needed to work. but stmCube inserted the full library.
There where Actually missing connections.
for example:
polygon of top and bottom in an area, was not connected.
Does unrouted net DRC has any parameter?
thanks
Hi
I designed a PCB with Altium 18.0.9 and I checked it with design rule check. It has reported no error for un-routed net. After I got the board and montage the component I fined some problems that their reasons were some un-routed!
I checked with DRC again and no error again.
I checked it in...
Dear
I made my SIM808 Evaluation board and i want to upgrade the module firm ware from UART.
In "SIM808_EVB KIT_User Guide_V1.00" , in part "Upgrade module’s firmware through UART port" , it is wrote : "Switch S105 and S102 to ‘On’ state".
S105 is Power Switch. But i don't know S102(Download...
Dear,
My device is work correctly.
Because my application has mobility, and in some locations there is no network coverage the response will be "AT+CREG: 0,0" . after movement and entering in a network coverage area, the module don't search network , and won't register for many minutes. i want...
Dear
One of possible response to AT+CREG? is +CREG0,0 mean : Not registered, MT is not currently searching a new
How can force the module to searching the network? Is there any command?
Regards
hamidreza
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.