Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
PIC16f877a is being detected by Genius G840 programmer.
I am trying to test an example code of LED Blinking,
the code is as follows.
void main() {
PORTC = 0;
TRISC = 0;
while(1) {
PORTC = ~PORTC;
Delay_ms(1000);
}
}
I am trying to burn the hex file of above mentioned code...
I am trying to burn hex file into PIC 16F877A into a genius programmer. I am getting an error when I select the device. A dialog box pops up stating "An unnamed file was not found" . How to get rid of this error?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
