Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi!
I'm new with cortex based AVRs, and I need a little help.
I have a SAM3S4B processor, 64-Lead LQFP. I want to program it with Atmel ICE programmer/debugger.
Made these connections
, on VVDOUT 1.8V appears, so the internal voltage regulator working.
Connected JTAG pins to the programmers...
Hi!
I'm planning to buy this accelerometer. But don't understand the datasheet. My first idea is, to use two wire method, and an external op-amp, but than found this sensor, and saw the three wire method. I understand, it can handle 5V input, but can't figure out the output voltage, it's going...
Hello!
Recently I bought two zigbee drf1605H module, and two drf2618A uart to usb module. Downloaded the DTK zigbee configurator, and TI sensor monitor. My problem is that, when I try to configure one of these module to router, can't change the Pan id, it's alaways shows FFFE in pan id field...
This is helpful, thanks. But, what happen, if I turn on the light. And one more question, there's a small flowing current, that may make the energy saving bulbs blinking, because it's charges the inner capacitors, isn't it? If it correct, is there any way to solve this problem?
Hi!
I'm interested in, to build a remote light switch, I succesfully made the remote, but can't make the power source.
I'm planning to integrate into the existing switch's place, so interested in a solution, that is using the existing cables, no need another cable, because the cable channel is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
