Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Adding more to the answer of @Palpurul, Normally the conversion time should be less than the time between the two samples are taken. For example, if your sampling rate is 50 Hz, i.e signal is sampled at every 20 ms, the conversion time should be less than 20 ms. If not, you may loose the next...
Hi all,
I want to control/automate CST MWS from python. I have seen the code for MATLAB where the control is done by writing a VBA script from MATLAB or directly using the COM commands.
But i would like to wish to use python to control CST using COM commands. As i see COM commands of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
