Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: UHF TV Transmitters
Thanks for the replies
flatulent,
with the major networks switching to digital transmission would that not provide more UHF frequencies to the smaller groups. By the way what frequency band will digital transmission use?
And why should analog equipment not be allowed...
Hi there
Our community is looking to set up a 24hour UHF TV transmitter.
Transmission frequency has not been worked out yet. That will be sorted out with the authorities later.
What we need to know is for a range of about 50km radius what type of transmitter would be required? That is at what...
barrybear
Does a higher signal level not indicate a better picture quality?
With a few free to air channel options, the site which shows the highest signal level for all channels should be the direction to point the aerial.
Is that so?
Thanks
gunmasterg9
Question on TV aerials
Could someone please provide a circuit diagram or a link which advises how the signal levels are measured from a TV antenna.
Basically I need to point the antenna in the right direction to get the best signals in 3 different channels (VHF and UHF - 2 separate aerials)...
Can someone please guide me to Electric Motors design type info or software available.
Please note: This is not electric motors for vehicles but induction motors (3 phase 400V, single phase 230V, etc)
I am working for a company that deals with such motors and any help would be appreciated
2...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
