Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: 555 ic timer curcuit
I put built the monostable circuit, but the problem with it is to reset the trigger, you have to turn the power off and back on again to activate the trigger again.
Ill give your one a go Hotwaterwiz and ill post up a result when im done.
Thanks,
Greg
Im currently trying to turn a Standard stopwatch into a race timer for slalom skateboards.
The main problem faced is that a stopwatch uses the same button for start and finnish.
The switch that i am using is a tape switch which goes on the ground for you to run over
activating the stopwatch...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.