Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
you have to know the internal characteristics of the ic... Not so easy !
But, if you are working with opamp, you may consider the inputs as high impedance.
Hello,
Using two diodes in parallel is not a good idea. Your diodes are not perfectly identical physically. The diode which has the smaller drop (0.6volt or less for a shotkky) will transfer all the power...
No ZVS here ... need some triming i think... for zvs, your drain voltage have to be as low as possible. Resonance frequency of your LC must shape your drain voltage in a semi sinus waveform. just like here :
**broken link removed**
I would say : " how much current is flowing through de 100 ohm resistance " ==> RI²
i'll put a 100nf ceramic cap for HF filtering.
How much wire length between power supply and transmitter/receiver ?
On your schematic here above. The network made from R1 R2 R3 C1 C2 allows U2 to know what's going on on the output and to react to variations. This is called "regulation". Using your function generator, i think you don't have this regulation anymore.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
