Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
about EDALIB 's HSpice support
quote from edalib web:
The models and subcircuits have been tested with the SPICE3F5-compatible simulator Electronics Workbench®. The libraries could be used with all Berkeley SPICE 3F5 and 100% compatible simulators, e.g. AimSpice(R), B²SPICE(R), CircuitMaker(R)...
I agrea with you,but to have a library containing most the models from most manufacturers is more practicable thane looking for each model whwnever neaded at the manufaturer website.
cnc stepper controller
I'm using PIC16F877 + 2x LMD18245 from national to drive bipolar motors i have found this solution the simplest for me : the LMD18245 integrate an H-bridge ,555 ,protection diodes ,current sensing ,bootstrap cap , interface logic,and can drive current to max 3A...
I got the same problem whith MAX418 using the supplied spice model from the manifacturer(Maxim) .
<font size=-1>[ This Message was edited by: gosth700 on 2001-06-02 01:15 ]</font>
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
