Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thanks for your reply
but do you mean it is two board attached (Paste) Together ? i did not under stand ?
because i saw in the video in youtube that the full board is copper ?
i dont understand some thing
i know how to make pcb using etching using chemical liquid.
but what about Isolate Routing method ? i saw some video show that making milling & drilling but how to remove ( isolate) the copper ? still all the board is copper
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
