Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Does anyone have the experience to translate .sdf file to constraint file under Astro?
I used the GUI mode as below :
>> Netlist In / SDF To Cinstraint
There was always showed :
***** SDF translation starts! *****
yyerror: syntax error
Error detected at line 18
Syntax error near line 18...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.