Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I will check :)
---------- Post added at 01:39 ---------- Previous post was at 01:37 ----------
Diego,
I did'nt understand how so many equations emerged? you worked backwards? is it?
Dear diego,
that is what i had assumed, but working backwards manually doens't match properly.
for example :
at 100 deg C, the resistance of the PT-100 is 138.4ohm, and working backwards using that equation it give about 150+ ohms.
Are you aware how to manually convert the ADC 0804 o/p to...
Dear all,
I am working ona project where i sense temp using PT-100, voltage comparator conditions the voltage to be between cmos limits. Following this adc 0804 converts A to D, and feeds to the micro-controller. the following is the cade, working fine! but i cannot understand a particular...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
