Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by gokul34

  1. G

    In open socket or without device i am forcing 100mv, in source side current is sinkin

    Hi, In my testboard,i am forcing 100mV in the power supply and trying to measuring the current with the open socket or with out device mouned in the socket. In the power plane, i have placed the 250uF bulk caps and decaps placed near the device near the device. like wise i have 12 power...
  2. G

    What is balanced PCB stackup

    Hi all, As far i know, balanced pcb stackup follows 1. signal layer should have adjacent power/ground layers 2. from center of the board(cross-sectional) top and bottom should have same amount or weight of copper and the di-electrics. If i am deviated from the correct concept please...
  3. G

    [SOLVED] What is meant by Jog-insertion in VLSI Physical Design?

    Can Anyone help me on understanding on jog cells & What is jog cells?
  4. G

    Polarised and Non-Polarised capacitors

    Hi all, I know that polarized having the + and - pins provided; non-polarized having flexible with pins connection. I am keen to know about the construction inside, which makes the capacitors differing from the polarized and non-polarized. Kindly help me by answering or direct me to clear...
  5. G

    Question on LDO basic concept

    LDO--> Low Drop Out Regulators is comes under the linear regulators. Its have pass transistor elements, this should work in saturation region, then only it regulates. pass transistor enter from the linear region to saturation region, drop out voltage is utilized My understanding is, To reduce...
  6. G

    what is ganged connections/routing?

    Hi everyone, I have doubt on the term "ganging". Is that means, connecting the two nodes together? what is the advantages and guidelines for this type of routing?
  7. G

    Find the highest and lowest number in array with PIC16F877A

    You can re-arrange the data in your program(by ascending/descending). then you can find the difference from first and last value.
  8. G

    PCB Design for Manufacuture guidelines

    Hi all, Please any one guide me on the DFM for PCB designing? What is Aspect ration and how its useful.
  9. G

    Please help ot YFF and DSE package information

    Please, anyone can explain about the YFF and DSE packages? Is this specific to the ti products or its the standard package?
  10. G

    Feedback resistor & gain of the opamp

    For both inverting and non inverting configuration,gain depends upon feedback resistance. What is the reason behind this? How its related?.
  11. G

    how to change the default suite in the orcad 16.3

    Hi Praveen, while starting orcad it is usually asks the different suites(design entry cis, pcb xl ...etc). i selected one and setted as default suite to start. but now i want to change that suite to another one. How to change this?. Please help on this.
  12. G

    how to change the default suite in the orcad 16.3

    Hi Everybody, While starting the Orcad software, it prompts for the mulitple suite i selected and setted as default. then how to change the suite once again. Please help me on this.
See more

Part and Inventory Search

Back
Top