Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If I have two resistors in series in a black box, like:
r1 a c 1k
r2 c b -500
then, if "c" is not accessible, it would be impossible (from a circuit theory perspective) to tell from I-V measurements of terminals "a" and "b" that this box contains anything other than a 500 Ohm resistor.
Hence...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
