Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have a horn antenna working at 144GHz with A=12mm and B=14mm. Then I'll illuminate a satellite dish of 57cm diameter with this antenna, with the feed located at the focal point of the parabola. I have the radiation pattern of the horn, made with MATLAB.
The goal is to know the beam propagation...
Hello everyone,
I have a noise distribution ( vecto/array) in MATLAB and I want to add it as an additional source to a circuit in ADS.
I have used the Data Access Component but not successful, it gives netlist flattening error which I don't understand.
I would be grateful if someone helps.
Regards
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
