Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
in DUBUS 1/2015 (www.dubus.org) was an article of a ham who built a
50W amplifier with a TriQuint module on 0.635 mm Rogers 3210 material.
It burnt eventually, and TriQuint is now Qorvo. device == TGA2312FL
The board was soldered to a metal block and the output stripline was only a
few mm long...
Probably you want to combine them just for PCB fabrication.
Leave the schematics alone and make a new PCB with copy & paste.
You need to use "paste special" or the identifiers and net names are lost.
Note that LOCKED components are not copied. I consider that a major bug.
If you really want to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.