Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Minimal diameter of a drill via: Dim=0.1mm (mechanical drill)
If you use UV laser, may be .04mm.
But it is more expensive when the diameter is less then 0.3mm.
If the current for vias is not the problem ,I think the hole size depend on you track density.
.45mm-.9mm is very cheap,and the position...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.