Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
As I can imagine, for the real measurements you use only one feed at the end of waveguide? Try to delete or turn off the second waveguide port in CST.
Hi Amir,
Just put Field Probe (Simulation -> Field Probe OR right click on folder Probes and New Probe...), set place and component of the field that you are going to save and perform simulation in frequency band that you need. The results you can see at 1D Results at folder Probes. BUT here...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.