Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The capacitor is on the crank input signal, and due to the back emf of crank relay which may be coming directly across this capacitor.
As I am not able to find the exact reason for this failure so, i am considering the dielectric breakdown of the capacitor due to to this back emf of the crank...
Hello Klaus,
Thanks for the reply.
The burnt may be has caused due to high transient current which in case have ruptured the dielectric of the capacitor as the pulse peak voltage is well above the dielectric strength of the capacitor.
As as of now, I can't make changes to add a inductor or a...
Hello,
I am facing a field issue in on of my product, the input signal capacitor used for ESD protection gets burned out. The capacitor used is MLCC type, 100nF, 50V and 0603 package.
I think so the due to the high transient voltage on the input lines this capacitor may be getting degraded and...
Hello,
I am working on the electronic throttle control for automotive in which a DC motor is used to control the ETC throttle body valve and for that I am planning to design a H-bridge Gate driver which will gate the MOSFET and in case will control the MOTOR.
Now, I have certain question as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
