Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
So I've started a spice circuit of my project based on what I've read from textbooks. I've attached the picture of the circuit and the outputs at each stage. My question is to how to avoid clippings at max. Thanks!
Thank you all for the advice. I'll be starting to sketch some diagrams and update you all on my progress. Hopefully you guys can help me make it simpler and efficient, as in professional level kinda.
Thanks again!
Thanks for all your replies. With regards to the project assigned to me, it is "Discrete Op-Amp" so I need to make an amp that has 2 inputs (+/-) with the specs listed on top. I'm starting to have some ideas on how to start the circuit but this part still confuses me:
3. Frequency response...
I have a few questions regarding my project. I'm a CompE major student so my analog skills are rusty. Thanks in advance, all my questions are in bold.
Design an amplifier which has the following capabilities:
1. Two inputs one plus , one negative
2. Capable of driving a 50 K ohm load to +/-...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
