Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
thanks but i don't know the command to do it
i only can acces its bootloader from terminal using serial
i store my program in NV RAM
i want to erase the entire ram wich is 32kb
the size of the hex is 78kb
the chip can be powered off but still remember data because of the batery attached to the...
hi there
i have 8051 microcontroller (ds5000fp) wich i programed my application inside external sram
i want to let it clear the content of the sram after x seconds after powering the microcontroller up
can i do it without modifying the hex i programmed inside sram ?
hi there
i want to program the ds5000fp but no luck
i have usb to ttl converter but i dont have the hc125
i connected RST to 5v and PSEN to GND
tried different baud rate
hyperterminal do no give any ascii message after powering the chip
is there a way to activate program mode without using HC125...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.