Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i am simulating a modal. the unit is hexgon and the grid is triangle. when setting the floquet port ,i wonder how to set the vectors a and b. i wonder which setting is right?thank u
Re: hfss11 master
ur instructions are very hepful,but i still have a question . How did u split one face into two and then assign M/S boundary 2,3 respectively ,
after reading ur article, I still dont know how to calculate the distance. Is there a formula to connect the distance to the frequence and incident angle? Why 4.7mm for the structure?
In my opinion, floquet port is also a kind of feed or excitation.the mode TE and TM should cover all the situation, I think. I wonder if my opinion is right.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
