Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by frenki

  1. F

    atmega parallel programmer (not isp) request

    atmega32 parallel programmer As i understand, discussion here gets about parallel mode - btw - supported by mentioned programmer.
  2. F

    atmega parallel programmer (not isp) request

    atmega8 high voltage programming For AVR parallel programer look https://www.der-hammer.info/hvprog/index_en.htm
  3. F

    Does it program PIC18Fxxx

    python pic18f Me, with this programmer i work fine with Microchip PIC 12x and 16x and Atmel 89x microcontrollers. Regards, Frenki
  4. F

    Bad bootstrap header, error message

    Bad bootstrap header I get mentioned error message where trying boot linux instalation CD on older Fujitsu ICL TeamServer Hs sparc machine currently running ICL NX. I thing that CD is OK (boot solaris CD on same machine produce same error). There must be problem with machine fw, I think. Have...
  5. F

    Req.: Fujitsu FD21 POS printer service manual

    fujitsu fd21 Hi, I am looking for Fujitsu FD21 POS printer service manual or any information regarding. thx Frenki
  6. F

    Does any one have information on the AS-I bus

    Some information could be usable **broken link removed**
  7. F

    Looking for 4/8-bit low power MCU for a battery application

    Look Elektor electronics - 11/2002 for LED Torch project project with PIC12C672.
  8. F

    How to chop binary file into smaller block in unix

    chopping a binary file in linux tar maybe?
  9. F

    How to wire DIL28 ZIF to program DIL chips in same socket?

    PIC programmer wiring Any idea how to wire DIL28 ZIF socket to be able to programm DIL8, DIL18 and DIL28 chips in same socket?
  10. F

    Pic Programmer Problems...

    Replace combination LED, D3 with zener 8V2. This should solve your problem .
  11. F

    PIC based power meter - what do you think?

    PIC based power meter What you think about attached wattmeter design?

Part and Inventory Search

Back
Top