Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
error:Waveform type must be specified if any waveform parameters are given
why?
everytime i use the vpulse in analogLib, this error jumps out
how can i fix it?
what's the acceptable difference between caculation and simulation.
the calculated drain current is much more than the simulated one
the schematic is a simple one, a common source circuit.
the parameter is obtained from .scs file.
thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.