Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In the top level of my heirachy I have an output signal "LED[7:0]".
I want to pass this into a lower level module to set a register.
I want to use the signal LED as an input in the lower level module.
The compiler throws an error and says there are too many drivers on LED.
Below is a segment of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
