Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
I downloaded 2PD601ASL.prm from **broken link removed** and tried to improt it in ADS for many times,but the ADS always did not has response.i dont know why?
Can anyone help me ?
Dear all,
i'm designing a RF amplifier(shown in figure),but i am confused how it happened when input signal level is more than 200mv?how can i avoid it only by circuit topology?
who can help me analyze the second case in detail?
Thanks!
Thank you, Sarma.
But the noise figure in that design downloaded from **broken link removed** is not mentioned.
Do u have other good suggestions for me?
Who knows the answer can contact me immediately by eamil: bigxu1979@163.com
Who knows where a LNA would be bought.The LNA is required as follows: operating frequency:10MHz to 30MHz, NF<1.2dB, gain>15dB.
In addition,if i want to design it by myself,what kinds of devices should i select?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
