Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I don't know the exact AL of the toroid, but I think it's over 100.
So, if I use 50 turns and 0.1R resistor for sensing a max of 10A, how would that be? How would I determine how to avoid saturation?
To avoid saturation, would I increase or decrease the number of turns?
What if I were to...
I was thinking of a small toroid with 1 turn, 100 turns and a 22 ohm load resistor. How accurate will it be? Will the voltage at the output of the current transformer (across the burden resistor) be linear? I want to use a ferrite core because it's cheap, easier to wind. Will there be any...
I am making a circuit for overcurrent protection where the circuit is shut off using a relay if current is greater than 10A. For current sensing, I chose to use a current transformer.
My question is that, if I'm measuring the current flowing through at 220VAC 50Hz, can I use a ferrite toroid? I...
The triac is BT134 rated for 4A RMS on state current and 25A non-repetitive peak state current.
The CFL is rated at 30W, 220V AC, 50Hz.
It is running from 220V mains.
I'm driving the triacs with 5v with a 1k-ohm gate resistor.
I hope this can help identify the problem.
---------- Post added...
I have made a circuit to turn on and off 2 CFLs remotely. For the remote control part, I used RC5 protocol. For turning the CFLs on and off, I used triac. I have a few questions here.
Firstly what I did was:
To turn the CFL on, the microcontroller kept the triac turned on as signal was applied...
Ok, thanks for that. I will do that.
I have a question about the battery voltage. In some places, I read that battery is fully charged when it reaches 14v, in other places I read that it's fully charged at 12.7v. Which is correct? I'm going to have a battery level indicator with 4 LEDs to...
What I have in mind is that, since, theoretically power in = power out. If I have a 100W panel that gives 20V output, I get 5A current for charging, but if I convert to about 14v, I get around 7A current. Losses are there obviously, but isn't this theory alright? Or am I missing something here...
Hey all, I am working on a solar charge controller for 12v lead acid battery. This is what I planned:
I am setting up a small inverter whose battery (70Ah) is charged by a 100W panel all day long (as long as required).
If panel voltage is > 13v, output to battery = input voltage.
If panel...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
