Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I changed the logging values to 10 ms i.e. it logs at every 10 ms. That should capture the event, right? I observe the same pattern as described above.
My question is whether the change observed should be so minute only and that too along one axis only? I mean, am I getting the correct data...
Hi,
I am not sure if this is the right section to post in but this seemed to be most fitting. Apologies elsewise.
I have taken up a standard accelerometer logger application in my android smartphone and recorded the data.
I placed it on a wooden table and noted down the reading per 100 ms...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
