Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello friends,
Please can any one help me to find good documentations about the "802.11u Interworking".
Please I need urgently any documentations about the 802.11u.
Thanks.
Firas.
Hi,
I am looking for CMOS based architectures of the four Controlled sources :
* Voltage controlled current sources (VCCS)
* Current controlled current sources (CCCS)
* Voltage controlled Voltage sources (VCVS)
* Current controlled voltage sources (CCVS)
OTA and CC based one are also welcome...
layout aria estimation
Hello friends,
I want to estimate the aria of the layout of my circuit. I know the size of transistors but I don't know the size of the aria to be occupied by routing signals and power.
Please can any one help me how I can estimate the aria of my circuit.
Thanks.
Firas.
hilditch algorithm
Hello Friends,
I need an Hilditch's Algorithm for Skeletonization of a fingerprint picture.
Please can anyone help me to find an algorithm.
Thanks.
Hello friends,
I want to simulate the THD of a folded-cascode OTA (differential ended structure) --> Figure 1.
Can any one know what is the best test-schematic of this component?
And how to calculate exactly the THD? (with TRAN simulation and THD command in the Calculator, or with PSS...
thd of rectangle wave
Hello LvW,
I use IC5x,
I don't find the "FOURIER" command in the the TRAN analysis toolbox,
Please can you help me, where I can find it.
Thanks.
Hello friends,
I want to characterize a comparator for Sigma Delta modulator,
Please can anyone help me to characterize properly this comparators (what are the simulations types to do?)
Thanks.
calculate snr in matlab
Hello ljy4468
Thank you for your help.
When I run this code, an error come out at the line 15 because the function calculateSNR.m is not found.
??? Undefined command/function 'calculateSNR'.
Error in ==> sdmcal at 15...
snr cadence calcualte
I do not know how to calculate SNR with cadence.
But in my case, I simulated & extracted data (0,1,0,1,1......) and calculated SNR with MATLAB.
If you want, I can send you my code.
Hello ljy4468
I have find many code that calculate the SNR with MATLAB, but everyone...
Hello friends,
I'm working on a second order switched capacitors sigma-delta modulator,
I want to calculate the SNR of the modulated signal (output of the modulator),
Please can anyone help me how to calculate the SNR of this signal with the calculator of CADENCE,
Thanks in advance.
snr calculation in cadence
Hello friends,
I'm working on a second order switched capacitors sigma-delta modulator,
I want to calculate the SNR of the modulated signal (output of the modulator),
Please can anyone help me how to calculate the SNR of this signal with the calculator of CADENCE...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.