Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sir, I am facing a problem while printing a pcb from ares. I have used circular pads and larger drill holes. But in the printout the drill holes do not come larger. However large hole drill hole I choose or not, in the output the hole size is always the same small default size. I am using proteus 8
helo tahmed Salam
l have the same problem ( Sg3525 pwm problem and changeover problem)i have made a ups it warks fine but when electricity fails from grade it not starts quickly and so computer reboots.
i have remove the capacitor from softstart pin 8/ decrease the value of resistor which conect...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.