Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi All,
Almost all literature refer to compression point and intercept point measurements in terms of input&output power.
When simulating a simple 2stage opamp, that has been designed to drive a capacitive load, how do you setup the simulation for input & output power ?
Thanks
Re: Pierce Oscillator Vpp Amplitude too low & Cannot converge sst for Phase Noise Sim
After i inject the vpulse to kickstart the circuit i can see that the oscillations start and the amplitude increases exponentially. However, after a short period ~1ms the amplitude stops at 1mVpp.
Digging...
Pierce Oscillator Vpp Amplitude too low & Cannot converge sst for Phase Noise Sim !
Dear All !
I have read nearly 30+ posts on this and still struggling to make it work correctly.
Simply i am trying to design a basic 40MHz Pierce Inverter Oscillator with the following Crystal parameters...
Forgive this quasi-blog, but id love to hear your personal experience, opposing opinions or simply a good debate about this subject that has been asked time & time again !
I have over 15 years analog/rf IC design experience, and once upon a time (many years ago) I would always have a handy...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
