Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
i want to a fulduplex voice communication( as a hot line) between 2 places that the distance is below 300 m.
can i use analog transmission and in baseband?
hi meridian
this is an instrument that we can test , in fact compare , windings.
it applies an impulse to a refrence winding and save the wave form of trasiant vibration of it then other windings could be tested by apply the same impulse and comparision of their treansiant vibration with the...
hi
by temperture variation Bjt's parameter will vary. but how we can reduce these variation?
hfe and Vbe are the parameters that vary with temperature. variation of Vbe will cause variation in Ib and variation in Ib and hfe will cause variayion in Ic. by biasing the bjt by a diode with same Vbe...
hi
i have PCB that one of its tracks burn and cut. its not a power track just for feedback , and maximum current of it is about 10 mA. what do you think about it ?
do you have any idea about what it happen?
hi
the pole of out pot filter in dcm flayback convertor is changed by load variation.
then the gain cross over point is moved. i want to know how much it is? is it possible that the cross over frequency move from 100 Hz to 5 KHz in no load and full load?
how can i simulate a switch mode power...
feedback loop design basic+flyback +smps
hi
how can we design the feedback loop of flyback topology when using DPAswitch or other similar devices
thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
