Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Sorry you are right i make a mistake in drawing but in real isn't float, it's like attached photo, and when i put a 100nf capacitor between the stage one and two only the output square wave frequency change and but already oscillate.
Thank you Dear keith;
ok right now i use LT1028 that i found it from some old board, I want to use this amplify for magnetometer too, as i say my coil resistance is about 6 ohms and its Inductance is about 7mh i use two stage Lt1028 with 100Kohm to 50 ohm ratio that about 2000 time so totally...
Hello Dear Keith
Thanks to your Reply, about source impedance it's about 6 ohms (it's a coil) yes you are right but i can't found Low noise amplifier in my area is there any way to do it? is there any source for study about amplify this range of voltage i want to learn more about this.
- - -...
How I can amplify a micro volts range to volt range?
Which type of op-map i must use?I have very low signal about 1 micro volt and i want to amplify it to about 1 Volts and measure it's frequency it's frequency is in audio range and almost is about about 1-3 KHZ,I use two stage of AD620 IC WITH...
Hi izwirlee_35
Thanks your Attention, I need Send Some GPS protocol DATA Such as GPGGA and some Other data Like MAchine ID to Remote Server Every 5 Seconds not minute.Ok i am trying to do with normal mode.
Thanks alot
Hi izwirlee_35
before i Do the automatic CR+LF Setting but the problem exict, right now when i use
GET **broken link removed** /HTTP1.1
I have Problem as before but when i use like below
GET **broken link removed**
it's ok and i can add data to my log file, in any website and help file said...
Hi
Thanks to your Reply,I use This At so many times and the resault is the Same as before.
AT+CDNSORIP=1
OK
at+cipstart="TCP","www.gpstracking.somee.com","80"
OK
CONNECT OK
at+cipsend
>GET **broken link removed**)
Connection:Keep-Alive(CR)(LF)
(CR)(LF)
CTRL+Z
resault is The same before...
Hi
I use This at command
AT+CDNSORIP=1
at+cipstart="TCP","gpstracking.somee.com","80"
at+cipsend
get /default.asp?=test HTTP/1.1
Host: gpstracking.somee.com
Connection: Keep-Alive
Accept: */*
but i get this error what is the Wrong?
SEND OK
HTTP/1.1...
Hi
I use This at command
AT+CDNSORIP=1
at+cipstart="TCP","gpstracking.somee.com","80"
at+cipsend
get /default.asp?=test HTTP/1.1
Host: gpstracking.somee.com
Connection: Keep-Alive
Accept: */*
but i get this error what is the Wrong?
SEND OK
HTTP/1.1 400 Bad Request
Content-Type: text/html...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.