Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hole does not exist as independent quantity, its just when a atom losses its valance electron brings a + charge on the atom, that is normally called hole. but the electron is nearby and combine with the atom when the attraction on electron ends. thats why permanent ions does not form.
your output voltage is 7v because the mosfets are not properly switching, they require almost 12v pulses at the base, u must properly saturate the base mosfet
check the voltage from the ir2110, amplify the voltage if you need to and they are getting heating because the mosfet in a single leg are...
hey
**broken link removed**
this is the circuit o FM encoder, i have simulated this circuit on proteus, got the required results.
but doing on hardware cause problem. the modulator is not producing the required output. the FFT of the signal before the bandpass filter shows lots of harmonics as...
using debugger.
how exactly...not using any of those modules and according to datasheet thses pin has default function of I\O port
TRISB define the port as out put port
# include <xc.h>
void main (void)
{
TRISB=0;
while(1)
{
LATB=0xFF;
LATB=0x00;
}
}
the above code dosent show 0xff on portb instead show 0xc8..
any idea why??
Re: 2nd Order RC Circuit
for a specific frequency u can randomly pick the value of resistor and capacitor
only thing matter the confriguraion you chose
the decay rate depends upon the value of Q...
consult this book
filter design by m.e van valkenburg
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.