Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I searched by google and it said that about 3.6@1k and 3.2@1M.But no one refer about the dielectric constant of PET at 900M or 1G.Does anyone here know?I was looking for it for a long time. Thank you in advance.
rfid ie3d
Just the sample of IE3D 12, the LoadedMeaderTag, it's pattern properties as following:
Frequency : 0.874 (GHz)
Incident Power : 0.0941603 (W)
Input Power : 0.00598268 (W)
Radiated Power : 0.0053095 (W)
Average Radiated Power : 0.000422516 (W/s)
Radiation Efficiency ...
I did a HFSS10.0 simulation on a dual core computer. When I set the number of solver to be 1, both of the two cpus' efficiency is about 50%;When I set the number of solver to be 2, the cpus' efficiency could research 50%-98%.However, this could only run for a while , then, both of the two cpus'...
What's your meaning ? I want to know what the port impedance should be when a RFID antenna attached with a complex impedance chip is simulated. It seems that 50 ohm is not very suitable for the port impedance.
Hello, all friends here. I am very glad to find this forum where people are so enthusiastic and friendly.
I am confused by a RFID antenna simulation problem for many days. If the chip's impedance is 20-j160, the antenna designed should have a impedance of 20+j160 for max power transfor...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
