Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, for beginner I just check the trace impedance, PCB stack up, driver & receiver strength/ODT and specification(topology), rise time of the signal and trace length spec.
Hi,
I think you cannot get the average impedance result from a line that has 4 microstrip & 3 stripline. Cadence will display it separately, you can open the SigXplor on Cadence. You will get the value separately on each segment.
If you drawing a system like that, I think you just have to draw...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.