Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: i want to drive a stepper motor at 8K rpm is that realis
These speeds are easily obtained with new steppers. You'll likely have to use current drive mode, and accuracy and torque will suffer a bit.
I've seen references using older high-torque steppers running at 2000 rpm, and then using a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
