Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
These are the waveforms: 1) Vb, 2) Vs, 3) to gate Hout.
The two images relate with engine ON and engine OFF.
When the engine is off you can better see the difference between VS and VB where Vb thanks to Charge Pump is polarized so that it can work in a continuous manner.
But now I formulate my...
Hello, I finally solved the problem.
is very important to maintain the voltage VB and for this we need a pump charg I made with a frequency of about 8 kHz. When the power to give way to VB to bring the right tension I had to delay the start of the UCC3626 using a trigger smit 4093. For a second...
Hello, to start my testing I used the UCC3626 circuit application information Texas. I tried small changes but without result. I can not get to work HO out of IR2110.
I tried to drive the mosfet with MAX4427 and the motor can stop and start without problems. But I would like to understand how to...
Thank you for your immediate response,
I use UCC3626. My engine has Hall sensors 120 °, two quadrant.
I believe that the problem is the management of the IR2110 in HO out that despite the bootstrap capacitor and a charge pump system, made with a 7 kHz oscillator, does not change status than its...
Hello, I use IR2110 to control power mosfet to power a three-phase brushless motor. I have to run the engine for a start. I mounted a charge pump that provides a voltage of 30V to VB but every time the PWM stop the engine does not start. VCC = + 15 = Vmot= + 24 PWM= 15 Khz
Every time I turn on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
