Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks a bunch Alex for all your inputs and for all your helps.
Is there ANY final difference if choice the POWER or the SIGNAL class?
Sorry but I've got 2 other question. I Think that the Proteus has a float scope or something so in addition to its common scope, Can you tell me Where is it...
Alex, I know where the zone mode is, But actually I did not get how to create a VERY wide trace (Please take a look at the ground trace of the link of my above post ) for ground and how to find POWER option?
I thought maybe there is a trick to wide the ground and VCC traces if needed by a button...
First thank a bunch for your helps Alex, You are very kind:smile:
Well, Actually I can not change any component's package value directly through ARES, When I change any component by right click on the component then want to edit the value of the components package I receive an error saying...
Yea, It worket thanks a lot Alex.
Thats excately what I did, But I could not perform the property!
Alex, So sorry for a lot of questions but can you let me know how can I incrase the width of the coper circles around the holes too? I want to add a wire on my PCB but the circle trace seems to...
Really I don't know the reason. to solve the problem I just changed the pachage of in the schematics mode, and then created the PCB. It works just fine and I could replace the RES40 by RES10.
Yea I found it . thanks for it.
Alex do you know how can I write my name on the coper section of the...
Thanks Alex,
It seems that I am not able to change the resistors to say RES15 directly in PCB section, right?
By the way I was not able to find the "track mode"?! I am using Proteus 7.6....
Thank you very much Alex for all your help.
I added it in my library but I am not able to use it because I am not able to see what You meant in your 3 last sentences. Can you let me know exactly what to do so that I could use it in the schematic and PCB sections?
By the way are you meaning that...
Hello guys,
I have several 0.4in resistors in Proteus software which want to movie them to PCB section. I just want to use the said resistors in Standup state so that reduce the size of my PCB layout. a size between 0.2 inch and 0.15 inch would be ok. Can you guys tell me please how to change...
Hi guys,
Can you guys please let me know where the ground pin of the scope is connected to in Proteus software?
For each channel we just accesses to one pin of the scope not to ground of it, So where the ground is naturally connected to and how to change it if needed?
Thanks
Alex,
I noticed that the fourier system in proteus does not work with signal generator, But for other generators it works just fine. I do not know the reason though!
Hi folks.
Sorry, BUt How can I change the default values for th voltages of a Chip?
For instance I am using a TL072 OP-AMP in Proteus but The default voltage for it seem to be 5V even when I connect the higher voltages to pins #8 and 4 of the said chip.
Or for some other chips There in no...
Thanks, Yea it works for now,
But it is strange I am not able to see the output FFT of my AM modulator! I just could see the FFT when a source Like a pulse source is connected to the probe!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
