Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for reply.
I am doing SMD was looking at some 0402 and sot23 mosfet packages. They would have low profile.
Would you think better not too mount directly mount under battery holder or better to use the other side of PCB
Hi Guys,
Doing circuit layout at the moment and getting tight on space, I have space under LI battery holder, clearance height of about 2mm. Is this ok to populate under or best to avoid such practice.
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
