Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi, i just run my simulation but it end up with this message:
[error] Port refinement, process abc3d : There are no tetrahedral faces assigned to boundary "Short". Since boundary operations are order dependent, please check to make certain that this boundary is not being ignored because of...
deembed hfss
Hi guys, i've been using hfss for almost 2 week now but i still haven't figure out some stuff :cry: . so i'm hoping some of u could help me see through the problems :wink:
so here it is:
in defining wave port:
- What does it mean by deembed port ?
in setting up analysis setup...
hi guys, I'm doin this project based on the article A.Sevinc and Levent Sevgi " Millimetre Waveband Semisymmetrical Groove Guide Resonator" IEEE microwave magazine 2004.
At the moment i'm tryin to simulate it using Ansoft HFSS but i couldn't seem to find a way to excite the dominant TE10 mode in...
Re: Groove guide resonator in HFSS- excitation problem
hi thx IICCEE for the reply,
but sorry i don't quite understand on what your suggesting.
could u be more specific please.
thx again
greetings all,
First off all thx for reading this,
i'm doin this project on Ring resonator operating in Ka-band (20-40GHz)
The problem is i couldn't figure out how to excite it through the copper slots (pls refer to model) to get the dominant TE10 mode in the groove region & get the output...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
