Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
power factor meter circuit
Hi....
I need your help in this circuit..
It should give the power factor of the load...
I need to calculate the value of T1 and T2 to test the circuit....
-what is the best available simulation software for such a circuit?
Hi xxargs....
Thanx for your help...It seems working Ok...I'm going to check it....
Thanx again
Added after 1 hours 5 minutes:
Thanx Engineer_Bob...
appreciating your help......
Hi everybody....
I have a problem that I could not solve, and really need a help...
It says:
In a factory, the following are the loads:
Induction motors: 1000 hp
0.7 average power factor...
Hi everybody...
Can anybody help me solve this problem about DC motor manually and by using software (i.e matlab, C++,etc..)..? Please..
here it is:
A dc series motor drives an elevator load that requires a const. torque of 200 N.m. The dc supply voltage is 400 V and the combined resistance of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
