Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I pulled up the resistor.
Controller supports I2C communication hardware .I am using r8c1B micro controller and for that i have written slave receiver and slave transmitter code.
the code is perfectly working when i am using two micro controller .One as a slave and other as a master but with...
I tried the same.
Through uart i am enabling the i2c on tc65 but if i am trying to see at SCLK pin of tc65 ,then i am not getting clock itself.I thought might be it is tc65 problem , i changed that also but problem remains same.
Hi
I am trying to interface tc65 and micro controller(R8 Tiny series) through i2c but i am not able to.With same code i am able to interface two controller.
TC 65 provides some AT command for enabling I2C communication at TC65 End and i am using the same.Is any extra hardware circuitry...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
