Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
A is right
as i know, SAB layer is used to block the salicide process, salicide nmos can't using for ESD protection, because it's low-resistance and bird-peak structure...
i'm not sure....
I need a accuracy resistor in my design, so i want to use fuse trimming. But how to design this trimming format! Should use metal fuse or poly fuse?
where to find some docs about fuse trimming!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.