Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Thanks for the reply. Please correct me if I am wrong. From what I understand, I should connect pin 5 to my copper trace and pins 1 and 4 through via to the bottom ground and pins 2 and 3 directly to the bottom ground. Am I right ?
Hi,
I am trying to fabricate a microstrip circuit and I need to connect it to an antenna using female SMA connector. But I am confused about the pins in female SMA connector. This is the connector that I wish to use. However, there are 5 pins and I am not sure which one of these I am supposed...
Hi,
Thanks for replying. I think I understand it now. So what you are saying is that when picking components for RF applications, I need to look for components that have SRF above my operating frequency so that I get the desired value of impedance. right ?
Sorry about that. I am operating at...
Hi,
I am a newbie in the RF field. I apologize for any stupid questions in advance.
I am working on a project in ADS and since the simulations gave me satisfactory results using ideal lumped components, I decided to replace these ideal components with commercially available models. So, I went...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
