Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Using voltage source and check the current is a necessity for me because I need electrical forming before measurement.
How to check amplifier stability? According to data-sheet it works well on 75Ohm cable... May be I need some kind of filter on output?
Thanks, I forgot to change.
OK, thanks.
Hmmm... Why not? I need to form fast voltage pulses about 10V/10ns, so i need enough current to recharge all parasitic capacitance.
You are right, I can use standart laboratory equipment, but I don't have scope and generator with fast external control. And one more thing - I need to control overcurrent during I-V measure. I think standard equipment is not so fast to provide feedback from scope to disable generator in case of...
My apologize, but I have lost some details on the topic start. My "diode" is not very simple. It is a non-silicon hetero structure which need some kind of electrical training. I need to form fast train pulses with programmly specified form and measure I-V characteristic after that. Next step is...
Beacuse of the magnetic field. It appears when you apply the signal and some parts of your transformer are shifted over others which are fixed better. Example: \ / -> ||
Hi edaboard,
How I developing hardware for characterizing 2port devices, primary special kind of diodes. It needs to be accurate enough and works at high speed, more than 10Msamples/s. Please, review my schematic :)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.