Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Help with NVR Ram
Try
https://www.datasheet4u.com/share_search.php?sWord=S2817A150
may you have to send an email to them also.
Hope this help...
electron1999
I will open it tonight. I think I will need care to...
I asked tek support recently, but they just say about fixing it for $1325 without any previous evaluation. It sounds a little expensive to take it as first option rather than asking for some help as I'm now.
It sounds interesting to check...
thanks for your interest.
I tried to use the troubleshooting chart but it doesn't seem to be enough for this case. In fact, troubleshooting procedure says:
Q: "Does the Scope display the power-up screen?"
A: Yes/
Q: "Does the Scope pass all the Diagnostics?"
A: No, but it doesn't display any...
tds3014b freezes
Hi all
Does anyone have experience with Tek TDS3000B scope startup problems :?:
I power up the TDS3014B oscilloscope and it shows the start-up screen but it freezes at this point:
I tried firmware but floppie disk drive doesn't seem to start at any time.
It only flashes...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.