Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I'm using an older, somewhat bonehead PCB layout program that has no obvious means of calling out slots, only round holes in pads. I need a slot to accommodate flat tabs from a connector. Slots will hold the connector in place as it goes over the wave, large round holes don't. What does a PCB...
Our company has used CircuitMaker/TraxMaker for years, but is considering the purchase of Proteus for PCB layout and schematics. My concern is whether ISIS can make publication-quality schematics for manuals, magazine articles, etc. I will be downloading a trial version to try to answer this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.